Fire Alarm-Only AMC in Dubai
A fire alarm-only AMC maintains the detection and warning system — control panel, detectors, manual call points, sounders and strobes, standby batteries and charger, loops and interfaces, and for connected buildings the Hassantuk monitoring link — in premises that have no wet fire fighting systems. It is the right scope for detection-only buildings such as small offices, single-tenant fit-outs and units where sprinklers and pumps are base-building landlord responsibility rather than yours.
DCD-approved · 12+ years in Dubai fire safety · Hassantuk-integrated · 18,000+ customers served
Detection without a wet system to maintain
If your unit has an alarm panel and detectors but no fire pump, sprinklers or hose reels — because the base building carries them, or the premises predate a wet requirement — then an alarm-only AMC is the honest scope. It keeps your detection compliant without charging you for suppression equipment you don't own.
- Small offices and single-tenant fit-outs with detection only.
- Units where the landlord maintains base-building wet systems.
- Older premises with alarm cover but no sprinkler requirement.
- Buildings on the Hassantuk network needing a live link verified.
- Tenants who must evidence their own detection at renewal.
Every part of the detection chain
An alarm-only AMC is not a lighter version of a fire AMC — for detection it is the full scope. QSERV tests the panel, samples detectors and call points per zone, proves sounders and strobes, checks standby batteries and charger, walks the loops and interfaces, and confirms any Hassantuk link is transmitting.
- Control panel powered, fault-free and function-tested.
- Detectors and manual call points sampled zone by zone.
- Sounders and strobes proven audible and visible.
- Standby batteries and charger load-checked.
- Loops, interfaces and any Hassantuk link verified live.
When you actually need more than alarm-only
Alarm-only is right until your building has suppression to maintain. The moment there is a pump, sprinklers, hose reels or a gas system on site, detection cover alone leaves you half-protected — a maintained alarm over an unmaintained pump is not compliance, and an inspection will find the gap.
- A pump or sprinklers on site means you need suppression cover too.
- Server or electrical rooms with gas suppression fall outside alarm-only.
- A maintained alarm over an unmaintained pump is not compliance.
- QSERV flags out-of-scope systems rather than ignoring them.
- Upgrading to a combined fire AMC is straightforward when needed.
Services & Guides For This Topic
Frequently Asked Questions
Answers for office tenants and building managers deciding whether alarm-only cover is the right scope.
What does a fire alarm-only AMC include?
It maintains the full detection and warning chain: control panel, detectors and manual call points, sounders and strobes, standby batteries and charger, loops and interfaces, and any Hassantuk monitoring link. It excludes wet fire fighting systems, which the building may not have.
When is alarm-only enough for my building?
When your premises have detection and warning but no fire pump, sprinklers or hose reels of your own — for example a small office or fit-out where the base building carries the wet systems. If you have any suppression on site, you need cover for that too.
Is an alarm-only AMC accepted by Dubai Civil Defence?
Yes, provided it covers every fire system you actually have. Civil Defence expects each system maintained under a valid documented contract; if your building is detection-only, an alarm-only AMC from a DCD-approved contractor is the correct and complete cover.
Does alarm-only cover the Hassantuk monitoring link?
Yes. For buildings connected to the Hassantuk network, QSERV verifies the monitoring link is transmitting correctly as part of the alarm-only scope, so a genuine activation reaches the monitoring centre.
What if I later add sprinklers or a pump?
The moment suppression equipment is on site, QSERV extends the scope to a combined fire AMC covering both detection and the new wet systems. Alarm-only cover alone would leave the suppression side unmaintained and non-compliant.
Do you upsell wet-system work I don't need?
No. QSERV scopes the AMC to the systems actually present. If your building is detection-only, you pay for detection maintenance and nothing more — and we tell you plainly if a system does fall outside the scope.